Industry News

Sharp corners and angles can impede the flow of the melted plastic material. These structure can cause the cavity not to fill timely and properly, easily producing part with defects.

There are plenty of logo processing technologies for plastic parts.

The purpose of an ejector pin is to apply a power to ejector a plastic part out from the mold, and this process can leave some marks on the surface through.

The purpose of mold testing is to make sure that the mold can produce qualified products, put into mass production, extend the service life of the mold.

The injection flash is typically caused by leakage of the melted material between the two surfaces of a mold, it greatly influence the quality.

A suitable mold packing method should be adopted by the actual needs of customers.

A hot runner system is an a device of heated components used in injection mold that inject melted plastic material into the cavities.

We should pay close attentions to the parameters involved in the molding process.

The undercut can be defined as the structure that influences the ejection process.