A mold gating system is a network of channels that deliver molten plastic from the injection molding machine nozzle to the mold cavity. It is an important part of the injection molding process, as it affects the quality and efficiency of the molded parts.

The equipment needed in injection mold making can be divided into two main categories: basic equipment and Auxiliary equipment.

Injection pressure is the pressure at which the molten plastic is injected in to a mold cavity. It is typically measured in tons per square inch(psi) or megapascals (MPa)

A draft angle is the angle applied to the vertical wall of an injection molded parts to assist with releasing the part from the mold.

PEEK injection molding is a process of creating parts from PEEK (polyether ether ketone), a high-performance thermoplastic. PEEK is known for its strength, stiffness, chemical resistance, and biocompatibility, making it ideal for a wide range of applications, including medical devices, aerospace components, and industrial equipment.

In injection mold steel, quenching is the process of rapidly cooling a heated part in a quenching medium, such as water, oil, or air. This process can harden the steel and improve its strength.

NAK80 steel is a precipitation or age-hardened mold steel with a uniform through hardness of approximately 40 HRC. It is super clean, Vacuum-Arc Remelted steel with uniform grain structure, uniform hardness, and excellent dimensional stability.

A plastic injection molding machine is a manufacturing machine designed to turn plastic polymers and resins into plastic parts and products. The injection molding process will essentially heat plastic material to its melting point, and the injection unit will force it into a created mold. Once in the mold, the part or product will harden as it cools, and the solid product will be ejected.

In injection molding, sharp corners can cause a number of problems, including reduced strength, increased old complexity, increased manufacturing time, reduced surface finish.

How to set the ejector pin?