The pressure in injection molding includes four types: plasticizing pressure, injection pressure, holding pressure, and cooling pressure. These four pressures directly affect the plasticization of plastic and the quality of products.

Injection-molded products have a wide range of applications in various industries. To meet the requirements of use, different kinds of tests are usually conducted on the product to ensure its stability. If design defects are found, they can be adjusted as early as possible.

Virgin plastic is produced directly from natural gas or petroleum and does not contain any recycled materials. Recycled plastic, oppositely, is made from plastic products that have been recycled into particles.

The injection mold cooling channel is a hole that is machined through the mold plate, mold core, and insert. It uses a medium (water or oil) to circulate continuously through the channel to cool the injection molded products.

There are several reasons why car bumpers are made of plastic: safety, production cost and ease of repair.

The timing-controlled hot runner system is a hot runner system that uses a time controller to control the movements of the various components in the hot runner system to achieve the desired molding effect. The time controller typically consists of a microprocessor, sensors, actuators, and control software.

Plasticizer is a high molecular material additive. When this substance is added to the plastic material, it can make the plastic more flexible and easier to process.

To determine if an injection molding machine is leaking, you can follow these steps.

Keep good record of your T0 samples, this will help you to track the changes you make to the mold, the material and the process settings.

Injection molding is a complex process, and one mistake can cause cosmetic flaws, compromise product integrity, and lead to expensive redesigns.