Industry News

The short shot refers to the defects that the melted plastic does not fill the mold cavity fully and make the product incomplete.

For a supplier, finished parts sticking in the mold can be an absolute headache, and how to solve it well?

The trial mold is a mold used to verify the product structure, product dimension accuracy, and other targets before the project officially starts.

DFM report is not only an efficient communication method in the industry but also a trustworthy proof of the manufacturing process.

This article will introduce you to three methods on how to demold a product with threads

Sharp corners and angles can impede the flow of the melted plastic material. These structure can cause the cavity not to fill timely and properly, easily producing part with defects.

There are plenty of logo processing technologies for plastic parts.

The purpose of an ejector pin is to apply a power to ejector a plastic part out from the mold, and this process can leave some marks on the surface through.

The purpose of mold testing is to make sure that the mold can produce qualified products, put into mass production, extend the service life of the mold.